B. FAQ

The sequencer

Who sets the order of trades? No single site. Each card calculates the same sequence from the same stamps with a fixed public rule. See 2.3.

How many times does an order go between sites? The client sends it to two or three doors. Each door forwards it one time to the other sites. Each site receives a maximum of one copy for each door, plus the copy from the client. See 2.3.1.

What occurs when a site receives a second copy of an order? The card identifies the copy from its hash. The card stamps only the first copy. See 2.3.1.

Can an order execute two times? No. The ledger uses each nonce one time only.

How many stamps does an order have? One from each site: six with six sites. Each card broadcasts its stamp one time. See 2.3.2.

How do six stamps become one time? Each card converts the stamps to one time base with the clock offsets and the fiber delays. Then the rule finds the median, clips each stamp to a band, and calculates a weighted average. One false stamp can move the result by a maximum of a published bound. See 2.3.2.

What occurs with two orders that arrive at the same time? Orders closer than the noise bound are a group. Random data that no person knows at the time of the signature sets the order in the group. Speed below the noise bound has no value. See 2.3.2.

Why does the card wait before it releases an order? The stamps of far sites are on the fiber for tens of microseconds. The card waits until the watermark passes the time of the order. The wait is approximately 0.1 to 0.2 ms (design target). See 2.3.3.

What occurs when the chain receives too many orders? The card rejects immediately with Rate, Credits or Barrier. The client sends again. The card never discards an accepted order. See 2.3.4.

Can a site trade before me? It cannot put an order before yours after yours arrives at the doors. It can delay the orders that enter through its own door, and you have other doors. One false site can move a stamp inside the published bound only. See 2.3.5.

The project

What is the objective? An exchange with a distributed sequencer, wire stamps and no front-running. See 1.1 and 1.2.

Is the testnet this system today? No. The testnet has one FPGA card and two software sites. Section 1.2 tells what exists today and what is not built.

Which market can I trade? BTC-PERP, with leverage up to 20x. The testnet uses test funds.

Who runs the sites? In production, independent companies, at least three. On the testnet, the DefiSilicon team runs all three sites.

Why an FPGA? The FPGA stamps the order at the network port, when the light becomes bits. No software touches the order before the stamp.

Why atomic clocks? They do not set the time. They check it. A site with a false clock makes evidence against itself.

results matching ""

    No results matching ""